Quote:
Originally posted by steelX:
Quote:
Originally posted by WolfmanX:
[b]
Quote:
Originally posted by steelX:
[b]
quote:
Originally posted by Kaiser:
because we know you have nowhere else to go." [Freak]
scary thing is, if slr or anybody else made an sas kit for the xterra, it would probably run about twice as much. [Freak] [/b]
Ahh, yeah true, but the quality would also be twice as good.[/b]
dont get me wrong, i think they make solid stuff. i just dont know why the stuff is priced way out of line with everyone elses. customer service is not that important to me. once you have the product, the likelyhood of having to deal with said company again is minimal unless you have a problem or buy something else from them.

not worth an xtra $$$$ for basically the same stuff, in my opinion.
Not to hijack the thread, but the extra $$$ is not a result of customer service. The extra cost comes from the added time that goes in to every product. IMO Calmini only goes as far as they have to go to put out a product that will "work" at a low cost. While SLR for example, goes that far and then three steps more, using higher quality metals, superior design techniques, heat treating, superior weld quality and so on. Do you think Steve at Calmini sits there and manufactures every Upper Control Arm that goes out? No, it gets outsourced. Spencer does it all, and his high standards go in to every product.

Most importantly, they stand behind their products. They don't make excuses or try to blame the customer.

I'm not an SLR rep by any means, I have just discovered facts that were already there. I gave Calmini a chance. They blew it. [ThumbsDown]

NOW BACK TO THE SAS JOB