!!! !!! !!! H E L P !!! !!! !!!

I dont know what i did but to me i've done nothing wrong. I went to swap out my stock headunit for a kenwood so i took the battery cable off took it out and realized i had the wrong harness. Put everything back in reattached the battery cable and now my VDC doesnt turn on when i push the button.

PLEASE HELP

It's off all the time now and iv tried everything to fix it.

Read your owners manual, on VDC SYSTEM--

--Starting with pg 5-30 thru pg 5-31--

--explains entire procedure !!

-- --JIMBO

The light will read "VDC off".. If the light's not on stating it's off, it's on.

Well the manual is good but i mean i was expecting a combination of ignition and buttons.

So all i have to do is start the car then drive for ten minutes at any speed above 10mph? I cant stop at all or make turns? Can someone answer this for me.

Normal driving is fine. It just needs a chance to reset.

I got the same light when I disconnected both terminals to clean some corrosion and install some of those felt washers. Cranked it up and drove about a mile and off went the light.

Awesome, thanks for the input guys i really appriciate all the help.