Where are your Torsion Bars Set to?

I adjusted my torsion bars recently to raise the front about an inch or so for adding BFG MT 32s. After increasing the height, I measured from the frame (where the front of the lower a-arm connects to the frame) to the ground. I am getting measurements of 11.5" on each side. For those who have made this adjustment, what measurements are you getting?

Thanks




------------------


[This message has been edited by fakie99 (edited 03-18-2001).]

[This message has been edited by fakie99 (edited 03-18-2001).]

This might help http://www.xterraownersclub.com/ubb/Forum24/HTML/000067.html

------------------
Kevin
00' Super Black SE 5 speed
31" BFG M/T's, ARB, Rancho RSX's
superblackxterra.tripod.com

FYI, fakie, remote links to images residing on Yahoo will not show up here. You may see it, but we won't.

jeff

------------------

thanks, i did not know that. indeed, i can see the photo right in the post. oh well....

what is the recommended procedure to get a photo on?

jim



------------------

same way you did, but use photopoint.

------------------
Blenderheads Xterra Homepage

Greg Moultrie
00 Aztec Red XE 3-pak
4x4 Auto