I have searched and found only one match for my situation attempted the directions to correct it but with no luck, the post is a couple of years old so I hope new ideas will help.

I am attempting to install an IAB but i cannot remove the three nuts holding the arm to the frame I have wacked at them with a BFH and no luck. The nut located at the base of the Idler arm is no problem but the three others are killer.



**Sorry Ian don't mean to jack you photo from your broken IA but I just wanted to be specific. Hope you don't mind.

Those other 3 are only on there with 50 or so pound feet of torque, and should just spin off if you are holding the bolt on the other side with another wrench.

That looks like it hurt a little