Here is our schedule (I guess I should add I am the other half of doing this SAS).

This weekend our goal was to get the 5.14s in and start on rebuilding the front axle. So far I have put in the new bearing races in the Dana 44, built up the new open carrier, and started the pinion bearing preload pack. I might get off my lazy ass and go back in the garage and get the pinion bearing preload setup proper and maybe even get to where I can run a pattern.

So our schedule:

This weekend get rear gears setup and in X (done)
Start on Dana 44 build (started)

Next weekend Kasier installs the rear of the kit (assuming the kit arrives) and when I get back from my business trip I will try to get the front axle completed and the mounts welded on.

The weekend of the 13th, 14th and 15th install and finish the SAS ready for Disney.

All of this hinges on the kit arriving before next weekend or shortly after and Kasier getting the rear springs installed before the truck arrives at my house on the 13th.

Pics











5.14 gear setup