TO continue watering down this thread.

The welds on the axle brackets LOOK at least as good as the welds on that SLR arm.

The welds on the arms look awesome.

To finalize, a good looking weld means chit. Kasier has personally seen a GREAT looking weld fail. T

Now about the kit.

The cal kit is awesome, very well built and everything is VERY tough. I was impressed, especially when comparing it to some jeep lift kits.

The instructions sucked ass.

Things to know:

1. Get a locknut for the drag link to calmini conversion tube 7/8" 18pitch.

2. The cross bar goes on the outside of the front shock hoops.

3. to install the springs on the fox coilovers push up on the bottom spring mount and it will slide off..then remove the snap ring and slide the mount off.

4. Set the springs 1 1/4" down from top of threads to top small spring, then 3 1/8" down from top of threads to top of plastic spring spacer.