Just put on the three set of Skid-row plates.
The instructions were very good as they
pointed out the "gas tank skid bolt".
That was the only problem that took the
most amount of time.
I was concerned about cross threading it.
(like the instructions say)
There was something that didnt look right
after I got past that.
When I put in the spacerblocks at the rear of the plate/cross member.
The "tank bolt" looked like it also needed
a spacer.And there was no more spacers.
so I took it back out and put some washers in..which ment fighting with it for another
20 min`s..But I got it..and They sure cover the "tender spots" well.
Now to test them..

------------------