Quote:
Originally posted by Dave03X:
It's my understanding that everyone that does an SAS with those things have them sag within a very short time frame...most either do a Spring over axle on them, or switch to a custom made leaf pack from SLR or Alcan. So, I'm not sure how "Calmini couldn't have heard much about the issue". Of course, like you, these are my opinions, your results may vary. I'll update you on it when I get them on during the SAS next month. I'm using them with an SLR 2" Shackle though..so perhaps that will keep it more even in the rear. I remember seeing Kaiser's SAS pics and his was ass saggy right after he put it on the Xterra. Ultimately, I'll either go with an Alcan pack after a few months, or SOA the Calmini packs and modify the rear driveshaft.
That's been my experience. I did my SAS about 3 months ago and the rear end is about 2" down from where it started. I have the front end as low as it can safely go (4 threads showing above the coilover locknut) and it's still a little bit higher than the rear.

I don't know what I should do... fab up some longer shackles? I have a Frontier axle housing available I could SOA with - but then the back would be way high.
_________________________
Warning! Do not sear the top of your neck hole in the molten lactate extract of hoofed mammals.