I've just installed the Nismo Cold Air Intake (16576-RND25) on my 2001 Xterra and I have one question and a couple of small problems with the installation.

1: Is the air filter supplied "pre-oiled" or do I have to spray the filter with K&N filter oil? This is not stated in the instructions.

2: The heat shield appears to be about 1/2" too tall. After installing the new intake, I cannot close the hood properly. Is there a smaller heat shield available or can I just cut about 1/2" off the bottom of the heat shield?

3: The 3/16" hose, which at one end attaches to the MAF sensor adapter pipe and at the other end, a vacum fitting on the vehicle. I'm not sure, but my 2001 Xterra does not appear to have a vacum fitting at the other end.?

Any ideas guys? confused

Thanks,

Paulgw.
_________________________
Email me if you live in the UK and own a Nissan Xterra. I know I'm not the only one, I saw a yellow Xterra on the M4!