Well for one, i NEVER said anything about building a street truck. For those of you who are intelligent and open-minded, thank you! To the rest...have fun being ordinary. I broke my driveshaft the otherday...so i will be getting one built by Thrash Driveshaft Specialists. Either a one or a two peice. Should be lighter and stronger than stock.

As for the turbo, it will be a little while, since i am buying a new GSX-R 600 in a few weeks and will also be looking for a 4WD Xterra to drive daily while the current 2WD enters its first stages of its build process. The turbo will be the last thing to go on, but I have decided to go ahead with the project and do it. In its final stage i hope it to look like this:

Using the TCF Suspension and Sway-a-way shocks front and rear. Fiberglass fenders in the front and an engine cage as well as full interior roll cage. So there is ALOT of work to be done, but an old shop I used to work for will probably be assisting me with the build. Im going to teach myself to weld and bend pipe and probably to the cage myself...very very strong (rolling at over 80mph might hurt if its not strong enough) Also the truck will probably be running 31x11.5 Wrangler MTRs next week and a small 2" lift for the time being.

Also, i think i was asked if i worked for a shop in SA...YES i did. I managed and accounted for SCI Motorwerks for about 8 months.