Can someone give me the measurements for the center of hole to center of hole on Calmini shackles (or similar).
I would like to build my own and save the $50.00
Actually the width and length of the bars along with the hole sizes would be great also.
Thank you.

Alan

I am sorry but I put this in the wrong section, I though I had selected the suspension section but it turns out I put it in the drivetrain section.
Can the moderator please move it to the suspension section.

Soooooorry

I doubt you could build them for less than $50.

Hardware will run you almost $25.
Finding the right sleeves may be difficult to fit the bushings correctly.
The shackles aren't straight either, they have a double bend in them, which requires a very large bender to make precisely.

Then you have to consider the time invested to make them...

Good luck. The measurments you need are already on your Xterra. Just add 2 inches hole to hole if you want a 1" lift (they sit at about a 45 degree angle).