I saw in another forum someone complaining about the screws that come with the calmini rack rusting. Is there a better screw setup I can use for the install?

Which screws? The ones that bolt the rack to your roof or the screws that fasten the rack together? If the later, I would just go get some comperable stainless ones from the hardware store.

x2

Well I wasn't sure which ones were talked about exactly. I think alpine might have been the poster.

Hmmm dont think it was me but the screws that attach it to the roof do have some rusting. The ones holding the rack together are fine.

You dont just reuse the Torx screws that fasten the stock rack?

I went out and looked, but I can not remember if new ones were sent or if they came from Calmini.