I'd like to come to the Mod Day if I can make it... just to meet some folks, hang out... maybe help if needed.

Anyone got directions to 2001frontier's place? Time to meet there etc?

I would like to stop by, maybe help, maybe point and laugh and drink beer. Directions and time? I'm coming from Richardson, 75 and 635 if that helps any.

Plano area folk. We can meet at the Wal-Mart on Spring Creek and 75 at say 0810 Saturday morning.

SurfTeach - Can you meet us at Courtesy Nissan?

Scott I'll meet you at the Walmart. I need to do some more electrical stuff...I'd like to run a fused 8 or 10 gauge power cable to a power block underneath the stereo for future eletcronics installs.

I'd like to also run a 8 or 10 gauge wire to the rear so I can set up my inverter and wire up some wall sockets into the plastic panels. I hope I have enough time.

Ram, Courtesy Nissan is north of me. I am actually between Beltline and SpringValley, so I can just meet you at the Wal-Mart at 8:10. What corner of the parking lot?

I'd say the one with all the modified X's in it.

Everybody's a wiseguy

As my dad says.. It is better to be a smartass than a dumbass.

The NE corner closest to Spring Creek. My truck is yellow, so we will be easy to find.

Oh, you did notice we are meeitng at Spring CREEK, not Spring Valley. I offered Courtesy Nissan as it is far closer to you than 75 and Spring Creek, but we will wait at the WalMart for ya.

So what mods are everyone doing? I plan to install my body lift, and hopefully raise up my ARB.

I'm going to see if I can cancel my Sat. appt. to make it up there (assuming AC gets me this thing in time)... anyone know anything about putting on a snorkel?

I know we get to mangle your fender to install it! I have a body saw that should work well for that. If not my jigsaw will.

Could we please leave the term "mangle" out? HERE\'S a pretty good write up on an install... look do-able?

Hehehe. If Carlton can do it, a group of guys like us should be able to. I am sure it comes with instructions anyway. Maybe he can chime in with any pointers from when his was installed.

Chris, wanna do lunch next week so I can see what you did to your truck?

Sure. We can do that. I won't have my tires until the week after that though, so it is probably going to look like poopoo with my bald donuts on there.

Anyone else from Austin area going? Besides you, Jason... and Chris... where the hell do you live?

2417 Maryel
Fort Worth, TX 76112

If anyone shows up to my house in the middle of the night I will shoot you!

Anyone got a hole saw?

What size? Is that what you want to use to cut through the fender? If so, and no one has one, make sure you buy a good bimetal one. I probably have the base part of the saw that screws into the hole saw itself.

Its ok my tires are bald too. I get new ones sometime in the next few weeks myself.

What are you getting?

Not sure on size... might have to pick one up when I get there and see what size I need...

Probably the Dunlop MT's as they are pretty cheap and rated almost as good as the BFG's

Actually, as stated in a independent research test they concluded that the Dunlap MT tires (last year) were rate best overall for the price when compaired against the other tire manufactures that make the same class tire but only charging a whole lot more for them.

See you guys on Saturday!