Smoked my tail lights.
Disclaimer: For offroad use only!!!!!

First.... You need to get some tail lights...

Second.... Take some 1500 (or higher) sandpaper and sand them down. wet sanding is the best but make sure to tape off all the parts that arent getting sanded so no water dripps anywhere it shouldnt.



Third.... wipe down with a soft cloth to remove all the dust and water. (the one on the left is sanded... and the one on the right is not)


Fourh.... Spray with you choice of smoking agent (I used VHT). Make sure you do extremely lights coats.... Remember you can always go darker... its very hard to go lighter. I sprayed them with about seven coats waiting 15 minutes in between.


Fifth... let dry for about three hours. Then sand them again with 1500 sandpaper (I dry sanded this time because i didnt know if water would mess it up or not)

Sixth.... wipe down again with a soft cloth.

Seventh.... spray them with your coice of clear coat. I used three medium coats and waited 15 minutes between coats. Let dry overnight.


Eighth.... spray with your choice of cleaner and wipe down to see if the paint cured.