Well, I aimed the headlights on my own. It wasn't to tough. I pointed the headlights at wall approx. 50 ft from the wall. Then I found the center of the truck and marked it on the wall. The next step is to measure from the center of the truck to the center of the headlights (remember to measure the height from the ground also so that you have the right height for adjustment too) and mark this on the wall with a big x. I used masking tape for the markings.

After this all you have to do is adjust the alignment screws so that the low beams show up on the wall slightly lower than center and to the right a tad bit.

This wasn't to hard to do and took approx. 30 min time.

I drive at night on my way home from work so I will be testing them tonite. I will post how it work tomorrow.

Scott

------------------
Math svcks!! -- Jimmy Buffett

http://www.gpxo.org

CRIKEY!! That croc nearly bit my arm off!