Right on! My install was easy as pie, all except for finding the correct source of power.

I removed the seat and that plastic molding held in place with 4 snap screws.

I put the controller box under the seat by pulling up the carpet and drilling small holes for the screws to fit into. There is just enough room for it near the driver's door just to the rear of the large bundle of wire that loops around under the seat. This place is easy to get to and allows for plenty of room for the box under the seat. Once the holes were done I placed the box on top of the carpet and installed the screws.

I then routed the power line under the carpet to the dash area and routed the ground wire back toward the controller box and scraped off some paint and anchored the ground to the body with a screw.

I put the carpet back on top and everything looks professionally done. I replaced the molding and seat and I am good to go.

------------------
Xavier
"I invented electricity. Benjamin Franklin is the devil"