Electro Ken,

I am not sure how the honking signal works when locking doors on stock remote but just wondering if there is any posibility I could connect one end of the relay coil input wire to the factory alarm/lock system so that I could get a short honk whenever I lock the doors? the other end of the relay coil input goes to (+)12v line. If it is posible, which wire am I supposed to look for?

I already connected a relay to the Horn line from the after market door lock wire, It works fine except it sends a ve..ry long pulse that made it so irritating to hear the horn go off for good 3-4 seconds. Instead of a short pulse signal it sounded like a theft alarm.

In case if you wondered how I connected the wires:

Pin 85 from the relay goes to door lock line of the after market one.
Pin 86 goes to (+)12v line
Pin 87 goes to ground line
pin 30 goes to the horn circuit

------------------
2001 Silver Ice
4x4 XE

[This message has been edited by Flames (edited February 06, 2001).]