After I put my skids back on yesterday, I cruised over to Apollo Communications (43rd Ave and Northern) and bought a PA Speaker for my CB. Its nothing fancy (only $20), but works well. Install was approximately 10 minutes.





To install, I had to remove the top of the airbox. Once removed, I drilled two 1/8" pilot holes for the mount. The screws are #10 x 3/4" pan head sheet metal screws. Once mounted, I routed the wire along the drivers fender and then toward the drivers side firewall. There is an access hole that has a rubber grommet. Move the rubber, and route the wire inside the cab. Once the wire is inside the cab, plug into the back of the CB.