Photo A


Two months ago I purchased a set of new UCA bushings for my SLR UCAs because three of the four were damaged or blown out. This may or may not have been caused by my not greasing them for about a year.

Over the course of the last two months one of the four sets of bushings wore out again. I've not been wheel'n. Only freeways and city roads. Any ideas on what I did wrong?

Photo B

Ok, second problem may be related to the first problem...
History, when wheel'n at Razor Road in CA desert. Bottomed out the front suspension very hard when while trying to charge to a large dune. This knocked out the alignment of the tires. I started to hear a clunck when the driver's side front tire would droop to the bump stops. Near the rear bolt on part of the LCA the the torsion bar bracket mounts to the LCA is touching a bracket that's welded to the frame (Photos C & D). On the passenger side of the vehicle there's a 1/4" gap in the same location (Photos E & F).

I would really appreciate any suggestions you've got on how to fix this? and what did I bend?
Photo C

Photo D

Photo E

Photo F